International Journal of Research (IJR) Vol1, Issue 8, ... This paper presents the results of an experimental ... more than 50% replacement of sand by copper slag. B. Tensile Test The procedure of mix is as same as that of the compressive strength test. Figure
copper slag as an alternative replacement material of sand by copper slag on mechanical and durability performances of HPC. Earlier research at the modes of utility of this waste material and subsequent picks up in strength and quality of concrete has been condensed in this paper.
Copper Slag Copper slag from Sterlite Industries India Limited (SIIL), Tuticorin, Tamil Nadu, India was made use of. Physical and Chemical properties of copper slag The slag is a black glassy particle and granular in nature and has a similar particle size range like sand.
Copper Slag: Copper slag is black glassy and granular in nature and has a similar particle size range like sand. The copper slag used in the study was obtained from the copper smelting unit of M/s Sterlite Industries Ltd., located at Tuticorin in Tamilnadu. Table 2: Tests on fine aggregate Sand, Copper Slag and Coarse Aggregates 5.
A REVIEW OF INNOVATIVE USE OF COPPER SLAG AND FOUNDRY SAND IN DESIGN MIX CONCRETE CHINMAY BUDDHADEV* JAYESHKUMAR PITRODA** ... This paper deals with the review of literature for copper slag and foundry sand as ... JOURNAL OF INTERNATIONAL ACADEMIC RESEARCH FOR MULTIDISCIPLINARY Impact Factor, ISSN:, Volume 2, Issue 12, January ...
Copper slag was used as a replacement of sand from 0 to at an interval of 20%. Copper slag was obtained from Taj Abrasive Industries located in Sikar, Rajasthan, India. Fig. 1 demonstrates particle size distribution of sand and copper slag and Fig. 2 (a) and (b) shows sand and copper slag respectively used in this investigation.
GGBS in concrete mix. In this study, partial replacement of Cement with GGBS and Sand with Copper Slag considered. Experimental study is conducted to evaluate the workability and strength characteristics of hardened concrete, properties of concrete have been assessed by partially replacing cement with GGBS, and sand with Copper Slag.
This paper manages the trial Investigation on concrete by partial replacement of fine aggregate with copper slag to improve the quality strength parameters, for example compressive strength, split tensile strength, and flexural strength of the M25 and M30 grade of concrete. Here the fine aggregate partially replaced with copper slag in concrete with 5%, 10%, 15% 20% by weight of fine ...
The paper examines the possibility of using copper slag as partial replacement of sand and Nano Silica as partial replacement of cement and super plasticizer and Viscosity Modifying Agent are used in self compacting concrete, in order to overcome problems associated .
durability tests on concrete containing copper slag as partial replacement of sand. In this report, M30 grade of concrete was designed and tests were conducted with different percentage of copper slag as fine aggregate in concrete. The results indicate that workability increases with increases in the copper slag percentages.
International Journal of Innovative Research in Science, ... The paper was focused on the characteristics of copper slag and its effects on the engineering properties ... concrete generally improved with the increase in amounts of copper slag used as a sand replacement up to 20%,
The incorporation of copper slag (CS) in asphalt pavements proves to be a good substitute in replacing the natural aggregates. This reduces pavement construction cost and plays a key role in protecting the environment. The CS can be used with Recycled Asphalt Pavement (RAP) material especially in ...
fine aggregate in reinforced concrete slender columns A. S. Alnuaimi ... The copper slag is generally similar to sand as far as maximum, minimum and average void ratios are concerned. The angle of friction of ... The results found so far are presented in this paper.
fume, copper slag, ironsilicate fines, waste foundry sand, imperial smelting furnace slag, etc. Most of these wastes are wellknown and successfully applied in the concrete industry, except for ironsilicate fines, which are relatively unknown in the literature and in practice. Ironsilicate fines as a fine aggregate in concrete Ironsilicate ...
Jan 16, 2017· Partial replacement of Fine aggreggate by Copper Slag and Cement by Fly Ash 1. 1 Replacement Of Fine Aggregate By Copper Slag And Cement By Fly Ash Ammini College Of Engineering, Mankara, Palakkad 1. INTRODUCTION GENERAL Concrete is the man made material widely used for construction purposes.
Jun 12, 2015· This paper provides the gist of the systematic review undertaken, involving evaluation, analysis, repackaging and modelling of all the literature that could be sourced on the subject. Copper slag .